BJ291 Ball Joint - 20mm Extended #GT86-DUAL When installing an offset rack

When installing an offset rack spacer on a 86/BRZ it is necessary to notch (aka cut) a section of the front subframe out for clearance

- Durable stainless steel shim with CNC machined contour to match the OEM knuckle- Shim design allows for arm length adjustment of 0mm

Alternatively you could use aftermarket rotors that do not have this internal lip

that are a common size bearing that can be found at your local bearing supplier

One of the most crucial aspects to maintaining your engine and your car's general performance

BJ291 Ball Joint - 20mm Extended #GT86-DUAL When installing an offset rackBJ291 OEM style replacement ball joint with +20mm extension for roll center correction. For OEM (non extended) ball joint shank, please refer to our alternate listing. NOTE: Sold INDIVIDUALLY We also carry spare boots to suit which can be seen by clicking HERE NOTE: If you are running OEM S14 S15 rotor the end of the LCA must be shaved for clearance due to the 20mm extension. Ball joints for S13 180SX A31 can be seen here: BJ291 Ball joint